IR signal works every time when in Manage mode, but only some times when connected to a button!



  • In the IR menu -> klick "MANAGE" -> click one of the kebab menus (...) and then "Play".
    The command works every time.
    But when the command is connected to a button and the button is pressed it only works every 1 of 3 or 1/6 times.
    The connection between the hub and button if ok, because i can se the Led blinking on the hub every single time.
    And the IR receiver is fine and can receive commands very fast from different remotes.
    i have tested this on all my 6 Hubs, with 6* 4 buttons, all have the same problem.

    It seems to be a software error since it works perfectly with the "Play" test action .


Log in to reply