Power automate run flow twice
spo_servis last edited by
I am encountering an issue with my Power Automate flow being triggered twice when using a Flic button. This happens specifically when I have the trigger in Power Automate set to react to 'Any' button press. However, when I configure the trigger to respond to a specific button, the flow is triggered only once as expected.
Here's the scenario: I have a flow set up in Power Automate that is supposed to be triggered by a Flic button. When I set the trigger to respond to 'Any' Flic button press, it somehow triggers the flow twice with a single press of the button. This double triggering does not occur when the trigger is set to a specific button - in that case, it works perfectly fine with just a single trigger.
I am looking for insights or solutions to this issue. Has anyone else experienced something similar? Is there a known bug or a workaround that I might be missing?
Any advice or suggestions would be greatly appreciated. Thank you in advance for your help!