@Emil OK, thanks for the responses. See you!

@Emil Sorry, I know how to detect the ADDRESS in the laboratory, but when the Flic is used by the user, my scanning device doesn't know the ADDRESS off all possible advertising devices, I need a service ID to filter the devices around.

@Emil You are right but I don't know the ADDRESS of the button. I don't need security, I need only to discover the Flic in proximity, connect and read Its information (MAC address), then disconnect.

Whit this data I can identify the Flic and my use case ends.

@Emil I don't want to pair. I need only detect when the button is pressed without pairing and the only possibility is to use public mode service advertise to do it since no service advertises happens in private mode and I can't detect if the device is Flic or another one before connecting.

Hi @Emil ,
thanks, it's just as I thought, but this condition is not explicated in the documentation, so I asked ...

I try this procedure because 30 seconds of advertising after the connection is too high for my application, I need a max of 5 seconds of total advertising, or better I need no advertising at all after disconnection.

Can you give me some tips to get this result (if possible to get it)?

Thanks.

Best
Sandro.

Hi,
I'm Sandro and I'm new to this forum.

I have this issue:

• Flic2 after factory reset -> OK

• Pressing down on the Flic and holding it for at least 1.5 seconds (red led) -> OK

• Flic2 advertise service -> OK

• Connect to Flic2 -> OK

• Send FORCE_BT_DISCONNECT_IND packet with restart_adv = 0 -> OK

• Flic2 disconnect immediattly-> OK

• Flic2 stop advertise -> KO

So after disconnection, the Flic2 restart advertise although restart_adv = 0

Thanks for the support of anyone.

Best,
Sandro.