Flic stuck in standby
I have a a flic hub situated in a downstairs cupboard and 2 flic buttons in a bedroom at the top of the stairs. One on the buttons stays connected with zero issues the other always drops to standby and will not wake.
What reasons are there that this button won't stay connected? And how can I fix it. It is currently hurting the WAP
@Emil I managed to check the battery and it was still at 85%+
I have disconnected and reconnected from the system and hopefully that will resolve it.
pauli.hartala last edited by
@paul-j-houghton I sort of grabbed the one I have attached to door frame and it came easily loose from the top leaving the mounting attached. Then I priced the bottom edge loose by a small flat screw driver. I had stupidly attached the button just above doorbell button so there's very little room to operate. The current of the battery measured just below 3V (cr3032). I have to try again with a fresh battery because this replacement didn't clip on and wasn't any better. I bought this button early last year.
@Emil How do you go about checking the battery?
They all started at the same time and used about the same amount, so I would expect the battery to fail on all of them at the same time.
@paul-j-houghton maybe it's running low on battery?