@Emil yes like @mullz said I was trying to manage the bridge via the button>actions>Modify Matter Settings and tap to edit didn't work.

Via the providers though its fine, didn't think to look there,

Thanks

@Emil yes like @mullz said I was trying to manage the bridge via the button>actions>Modify Matter Settings and tap to edit didn't work.

Via the providers though its fine, didn't think to look there,

Thanks

I had my Matter Bridge commissioned to my Flic hub and all working great,

Accidentally I managed to decommision the bridge from the flic fabric via the iOS Matter settings but it didn't remove from the flic app.

Now I'm in a state where the flic app thinks there is a bridge (and all its associated devices) there but it shows as offline and I can't remove it.

I managed to recommision the Bridge back to flic but now I have a duplicate set of 22 device in my list!

Is there a way I can remove the old bridge from the Flic Hub?

I'd really like to be able to use the Twist to adjust the SetPoint on a Matter Thermostat, I can't quite figure out a clean way to do this with the Advanced and Matter Other settings either.

Perhaps if the Twist had an advanced feature that could just map increment/decrement commands rather than specific positions it would be a more useful, One of the things I love about the original flic buttons is their simplicity of being able to just configure a button press to an event mapping.

I'm wondering if there's a way to programatically deploy (and start) a module on a hub, if I have a given set of details, IP, username & password. I assume the hub would need to be in SDK enabled mode but I'm trying to reduce the steps a user needs to take to connect their Hub to my application.