@petter-landing-0r the red LED blinking typically indicates low battery. Did you try a fresh one?
-
My buttons use a mix of integrations. All are working fine except any that use the Alexa integration. The problem started happening at the same time as reports of the outage.
For example I have a couple of buttons by my bed. Both use a mix of Alexa and Homey integrations for different types of push. The Homey ones work fine (including those that interface with Alexa via Voice Monkey) but the ones that integrate with Alexa do nothing. The hub is not showing any issues and the problem persists over a reboot.
Is there something I need to do to get them working again, or do I just need to be patient?
-
Hi, I'm trying to use the new SDK features for the twist. I have created a virtual speaker device in the provider settings, but when I go to connect it in the twist configuration, it doesn't show up as a speaker under volume control--the only provider listed is Sonos. I've also tried adding a virtual device as a light and it doesn't appear under brightness or advanced dimming.
My Hub LR is at firmware level 4.5.1. I'm using the android app version 4.0.10.
4a7e9c26-b53a-402a-a13e-c7767905ef1d-image.png
3c99127a-60b1-4dfa-bb40-7f30676d629f-image.png
-
I bought 3 buttons + hub ~3 years ago. Worked most of the time the first 2 years, then they became very flaky and unreliable, so I unplugged the hub.
I'm trying again now, as it was quite cool product and want to give it another chance.
One of the buttons disconnects after few minutes: I keep pressing on it for ~10 seconds (trying to make it recognized by the hub), it blinks red. After 3-4 attempts, it finally blinks green twice, and the controller then works. I can use it few times in a row, but if I let it rest for 1 or 2 minutes, I have to do the long press dance again (red blinks..). I'm 1 meter from the hub -> totally unusable.
The 2 other buttons can stand a little bit longer (~10 minutes, 2 hours) before I have to reconnect them as well (long press with red blinking)
The hub is running firmware 4.5.0.
Any idea? -
Is there a possibility to change the name of the Flic button that is visible through Bluetooth? I can change the name in the Flic app but the actual Bluetooth name always shows up as "FLIC" which is not handy because we use a bunch of these buttons for race timing and it makes it hard to identify them.