@pociask Hi, we are testing every button at the production site including the battery voltage of the included battery, so we can assure you that no buttons leaving the factory have low voltage. The issues in this thread are related to issues we had with the old Flic 1 and are not relevant for Flic 2. In case a customer notices that the battery drains quicker than expected, we will of course send a replacement.

@Emil Hi there, hope all is well. Any thoughts on when you'll be able to add Sonos favorites? Thanks!

@flic-1b Hmm, sorry but this is a mistake on our side.

I have found your email in our support system and I will instruct my colleague to go ahead with the refund. Again, sorry about this.

@msiekkinen This is great!!! So what did the final install look like? Has it held up?

@rob-loosx @admin-flic Funny, before I bought the Flic Twist my expectations for how the selector was going to work was similar to how you describe it. My thought was that you turned the selector to a position and that then identified which virtual button you were using. All actions (push, double push, push/twist, hold, etc...) would continue to apply to the virtual button that you'd selected until you changed the selector to a different virtual button. In essence, you would have 12 buttons in one that didn't always reset to the main button after every use. So a little different from how you describe it. And a little different from how it works now where the selection is only temporary. Granted, if you wanted to know which selector was active you might burn battery life with a light on. Maybe you add a motion sensor so the selected button light comes on when you're in front of it. But again, more battery. Just thinking out loud.

@Emil hi it worked for me with some syntax change replacing - with :
so just change D7:E2:G3:XX:XX

@roger-0

error response on phone is is A type is missing a value

@vesa
With the new Matter update, I'm in fact using a flic button as a doorbell button, together with Home assistant. It's working great with the Matterbridge addon, and a Boolean helper that's visible in the Flic app.

@john-j-baumbach FYI: this was fixed in the Apr 2 2024 release of the Android app. Button works again!

Flic => HTTP request => Shelly

You should be able to send a HTTP request to the shelly with your flic. A bit of googling (or ChatGPT) should give you the appropriate payload.

I am not sure if Shelly accepts a "toggle" command, if not you may need a click for on and double click for off.

Good luck

@simonbrohus794
Hi!

Yes, there is!

You can use Flic Universal to configure the Flic button to act as a Bluetooth keyboard and program different key combinations to be triggered when you press it.

You can read more here:
https://flic.io/flic-universal

Hi there,

Thanks for contacting us!

You could connect August Home´s smart locks through IFTTT. Please find more information here:

https://ifttt.com/connect/augusthome/flic

I hope this helps!

Best regards,

The Flic Team