New Flic 2 button says it's already connected to hub
-
I have several flic 2 buttons and a hub already in use. I just opened a brand new box of flic 2 buttons and began the install process. When I reached the part where the button is pressed for 10 seconds for the hub to recognize it it says that the button has already been setup. The button does not appear on my device list. I tried repeating the process several times with same result. I restarted my hub and tried again to no avail. Any ideas why this is happening and how do I reset the button or get it to connect? Thanks in advance.
-
@Emil I found the error, and I'm not sure if I will admit it... But I had an old RPI running that I tested some flic buttons on some years ago (first release). Maybe I should clean up what I have running on my network...
-
@andreas-henden what is the LED colour and pattern on the button when you try to connect?
-
I have the same problem! If enter the flic hub SDK and try to start the scan on the console I also get an error like this:
scan
Scan started...
Bulk scan error: AlreadyConnectedToOtherDeviceGet the same error as @ems220 on my phone
-
@ems220 what is the LED colour and pattern on the button when you try to connect?
-
-
@ems220 exactly what message do you get? The only time the setup should fail is if the button already has an active connection ongoing to another device (requires the devices to be in range).
