'Could not connect' message at login FlicSDK
After an unexpected power-down i can't login to the SDK.
I did not change the Hub-password (at the back)
I do get login-screen at https://hubsdk.flic.io/ and Hub is detected.
After putting password in there is a message 'Could not connect' in a red box.
With the app on my phone i can connect to the Hub.
I am using firmware 2.0.19-sdk2
There is an option/button to change the password .."succesfull changed",
but still the 'Could nog connect' message at sdk-login.
The problem was
- old firmware (could not update myself)
- with new firmware the 'sdk-switch' in the flic-app was turned off, by default
-> red dot in the sdk-login-screen
- turning sdk-switch to on
-> green dot in the sdk-login-screen
-> login works!
thanks @Emil for the directions
abboberg last edited by abboberg
@Emil a red dot! That is on the login-screen, next to the found Hub with its IP-adress
@abboberg Edge v93 works fine for me. Do you see a green or red icon on a hub listed on the welcome screen?
@Emil I am now on Hub version (firmware) 3.0.10. But still 'Could not connect'.
Tried on Brave-chrome-browser (with shields off) and Edge.
@abboberg Fw 2.0.19-sdk2 was an old beta firmware that is no longer compatible. I've removed everyone on that track to be on the current. If you do a fw update now you should get a version that works.
did a hardware - reset, deleted flic2-buttons and hub from the app
reconnected to the FlicHub, added a button to the app (firmware was not changed)
connecting with password from the back of the hub; logging in with the app works
entered wifi-credentials again, at router (and in app) new ip-adres visable
but still message 'Could not connect' when logging in @ flic.io
same from desktop (wired lan) as mobile phone with Chrome