Flic Home

    Community

    • Login
    • Search
    • Popular
    • Users
    1. Home
    2. abboberg
    3. Posts
    • Profile
    • Following 0
    • Followers 0
    • Topics 2
    • Posts 7
    • Best 0
    • Controversial 0
    • Groups 0

    Posts made by abboberg

    • RE: Flic2 eats batteries

      @Emil i added a request

      posted in General Discussion
      abboberg
      abboberg
    • Flic2 eats batteries

      I have four Flic2's connected to the FlicHubLR.
      One of my Flic2's is draining any battery.
      Normally i use normal noname CR2032, last time i used an expensive Duracell CR2032. But even that battery was low in a few weeks. It is located about 5m from the hub.

      In the mean time i also reset my FlicHub and had to re-assign all my Flic2's to the hub (in the app).
      The other three are working fine and one of them i replaced the battery a month ago. No problems since.
      It is even further away from the hub and on another floor of my house.

      What could be wrong with the Flic2? Is there a debug-mode to see if / why it is on all the time?

      posted in General Discussion
      abboberg
      abboberg
    • RE: 'Could not connect' message at login FlicSDK

      It works!

      The problem was

      • old firmware (could not update myself)
      • with new firmware the 'sdk-switch' in the flic-app was turned off, by default
        -> red dot in the sdk-login-screen
      • turning sdk-switch to on
        -> green dot in the sdk-login-screen
        -> login works!

      thanks @Emil for the directions

      posted in Flic Hub SDK
      abboberg
      abboberg
    • RE: 'Could not connect' message at login FlicSDK

      @Emil a red dot! That is on the login-screen, next to the found Hub with its IP-adress

      posted in Flic Hub SDK
      abboberg
      abboberg
    • RE: 'Could not connect' message at login FlicSDK

      @Emil I am now on Hub version (firmware) 3.0.10. But still 'Could not connect'.
      Tried on Brave-chrome-browser (with shields off) and Edge.

      posted in Flic Hub SDK
      abboberg
      abboberg
    • RE: 'Could not connect' message at login FlicSDK

      update:
      did a hardware - reset, deleted flic2-buttons and hub from the app
      reconnected to the FlicHub, added a button to the app (firmware was not changed)
      connecting with password from the back of the hub; logging in with the app works
      entered wifi-credentials again, at router (and in app) new ip-adres visable
      but still message 'Could not connect' when logging in @ flic.io

      same from desktop (wired lan) as mobile phone with Chrome

      posted in Flic Hub SDK
      abboberg
      abboberg
    • 'Could not connect' message at login FlicSDK

      After an unexpected power-down i can't login to the SDK.
      I did not change the Hub-password (at the back)

      I do get login-screen at https://hubsdk.flic.io/ and Hub is detected.
      After putting password in there is a message 'Could not connect' in a red box.

      With the app on my phone i can connect to the Hub.
      I am using firmware 2.0.19-sdk2
      There is an option/button to change the password .."succesfull changed",
      but still the 'Could nog connect' message at sdk-login.

      posted in Flic Hub SDK
      abboberg
      abboberg