@Y2K I believe I can now, I have a SonOff iHost Hub, it connects with HomeKit, I also have a Flic2 LR Hub. the hub bridges to Homekit, and so does the SonOff so my SonOff devices can be triggered via a pass thru in scene controls and basic basic basic automation.

Wow 14 days go by with out a reply ?

Is anyone out there ??

@pontus The button's firmware won't boot if it detects that the voltage is below 2.2 Volt, resulting in that the LED stays on since that is the default hardware state. If you are sure the battery is good, please try inserting it again.

@trdn89 it’s insane that they haven’t figured out how to make twist send an IR signal for controlling volume.

@peter-2 concur on having a way to just twist and have stuff happen at each of the 12 positions without pushing (which btw seems to work so and so)

+1 on this - I bought the Twist to create an old school transistor radio experience where you turn the knob to tune into different radio stations.

Don’t really understand why we’re limited to 4 steps there.

Plz add advanced mode for the blender so we get 12 steps! 🙏🙏🙏

@leonardchrist I know I'm super late to the party, but the fact that the hub never ACKs the SYN ACK, plus the fact that it then re-xmits the SYN makes it seem like it never gets anything back. A couple obvious things to check would be the SN mask, and any possible ACLs/VLAN config on the switch ports. Alternatively, you could swap the PC/Hub switch ports and see if the behavior changes at all.

Alternatively, you could take a deeper look at the SYN ACK from the PC and compare it to the successful equivalent from the WiFi scenario. Hardware failure on the switchport, or hub, might cause it to fail MAC checksums.

In order to get some of my flic2 buttons open to replace the batteries, I had to peel the adhesive off from the back and replace it with stronger adhesive. I used the black foam 3M automotive tape. That allows the buttons to stick to surfaces stronger which allowed me to finally twist the covers off successfully.

@Emil via Alexa routine, and yes I've tried removing/recreating on Alexa itself. Triggering routine directly on Alexa works fine. As noted, the setup has been working for 2+ years, until it didn't.

@john-j-baumbach FYI: this was fixed in the Apr 2 2024 release of the Android app. Button works again!

@michael-4 Probably the response is too big to fit in the RAM memory given to your application. Do you know how big the response is?

@Emil wow, thanks a lot! 🙂

@Emil Thanks for response! Good to know its still coming. 🙏

@adam-setch Not at the moment. What is your use case in case you want this to be supported?

Any further updates on supporting this?

@flic-17 Interesting. May I know your use case or what you are controlling with your rotary encoder?